Apparently Polygon FD Premier 2008 SR Suntour I have started to show his age. After several setup finally starts his limiter screw hole in the retaining section.
Material retaining screw limiter Front derailleur SR Suntour made of plastic material, which will sooner or later consumed by this limiter screw, so if you have anything like this get ready just like me.
If indeed you are looking for an excuse to upgrade, this could be your reason to the Minister of Finance. but when upgrading or buying new is not an option, especially if it feels the damage is too trivial to justify the expenditure, then fix it.
How to fix it? very easy, its capital is only a small iron plate and glue sticking fast. The point is to patch the hole with a stronger material, the choice of patch material and glue creativity and customize to your budget, to facilitate the work, remove the FD of the bike.
If I, for plate iron using iron plate of the former and glue the rubber wiper such rapid adhesion Alt * co. It costs less than Rp.5000 / approximately ($ 0.5)
Material retaining screw limiter Front derailleur SR Suntour made of plastic material, which will sooner or later consumed by this limiter screw, so if you have anything like this get ready just like me.
If indeed you are looking for an excuse to upgrade, this could be your reason to the Minister of Finance. but when upgrading or buying new is not an option, especially if it feels the damage is too trivial to justify the expenditure, then fix it.
How to fix it? very easy, its capital is only a small iron plate and glue sticking fast. The point is to patch the hole with a stronger material, the choice of patch material and glue creativity and customize to your budget, to facilitate the work, remove the FD of the bike.
If I, for plate iron using iron plate of the former and glue the rubber wiper such rapid adhesion Alt * co. It costs less than Rp.5000 / approximately ($ 0.5)
SR Suntour front derailleur Polygon Premier 2008 image
Concave-shaped part that screws on the plastic retaining high | low limiter is indicated by the yellow arrow.
The concave part is closed by an iron plate
It seems easy right? It's easy. The hardest part is only an iron plate positioned just below the screw, that's it, use tweezers to help you.
It seems easy right? It's easy. The hardest part is only an iron plate positioned just below the screw, that's it, use tweezers to help you.
Source : http://akudansepeda.blogspot.com/2011/06/cara-memperbaiki-hi-lo-limiter-front.html
0 comments:
Post a Comment